Home / Navimow / i2 AWD Error Codes
The mower is having trouble communicating with the charging station.
Reviewed October 5, 2026 by RobotMower.help. Independent guidance checked against the official manufacturer documentation.
Confirm the station is plugged in and powered. Wait for the red lights on the mower and station to change, then press STOP to clear the code.
If the code returns after one controlled retry, preserve the evidence and contact Navimow support rather than repeatedly resetting the mower.

| Code | 4108 |
|---|---|
| Official meaning | Charging Station Communication Error |
| Likely area | loss of station power, an incomplete mower-to-station connection, or an internal communication fault |
| First action | Confirm the station is plugged in and powered. Wait for the red lights on the mower and station to change, then press STOP to clear the code. |
The mower is having trouble communicating with the charging station. The code identifies the system reporting the fault, but it does not by itself confirm which component must be replaced.
The most useful owner checks concern loss of station power, an incomplete mower-to-station connection, or an internal communication fault. Keep them external and reversible so you do not create a safety risk or remove useful diagnostic evidence.
Error 4108 belongs to the i2 AWD hardware and communication cluster. Compare it with error 4101 for internal communication, error 7102 for wheel-encoder data, and error 6110 for motion-control response.
Complete the official steps and supervise one short task. A single cleared alert may be temporary.
Stop repeated resets. An immediate recurrence points away from a one-time condition and toward a fault that needs manufacturer diagnosis.
Turn the mower fully off before checking wheels, the underside, sensors, buttons, cables, or charging contacts. Do not open the battery pack, steering assembly, motors, ACU, IMU, or sealed electronics. Do not force wheels or steering parts.
The mower is having trouble communicating with the charging station.
Confirm the station is plugged in and powered. Wait for the red lights on the mower and station to change, then press STOP to clear the code.
Only after the code clears and the mower completes a short supervised test without abnormal movement, steering, charging, positioning, or safety behavior.
Contact Navimow support when the code returns after the official steps, appears immediately after restart, or the mower cannot operate safely.
If you started with the mower behavior rather than the code, use our guide to charging-station communication problems. It compares this alert with similar i2 AWD faults.
Segway Navimow support documentation for error 4108. RobotMower.help is independent and is not affiliated with Segway Navimow.